Slim Line Features

• Smaller nose diameters than standard

• Balanced to 25,000 RPM at G2.5

• Maximum T.I.R. only .0001"

Slim Line holders are great for finish passes where small nose diameter tooling is required.

 

RUN FASTER: Spindle speeds and feeds are increased to reduce cycle times & increase R.O.I.

RUN BETTER: Shrink Fit permits better balanced chip loads so machining is more accurate and finish is improved.

SAVE MONEY: Tool life is extended by as much as 700% dramatically impacting your tooling budget.

Click HERE to learn more about Shrink Fit tooling

Refer to the chart below to order CAT 40 Slim Line shrink fit holders.

CAT 40 Slim Line toolholders

HSK 63A Slim Line toolholders

HSK 40E Slim Line toolholders

HSK 63A Slim Line toolholders

HSK 40E Slim Line toolholders